Advertisement
Command Modes
Usage
Information
Command
History
debug ip bgp keepalives
c e
Syntax
Parameters
Command Modes
Command
History
Usage
Information
debug ip bgp notifications
c e
Syntax
756
|
IPv6 Border Gateway Protocol (IPv6 BGP)
EXEC Privilege
This command turns on BGP soft-reconfiguration inbound debugging for IPv6 unicast routes. If no
neighbor is specified, debug is turned on for all neighbors.
Version 8.4.1.0
Added support for IPv4 multicast and IPv6 unicast routes
Version 7.8.1.0
Introduced support on S4810
Version 7.7.1.0
Introduced support on C-Series
Version 7.2.1.0
Introduced on the E-Series TeraScale
Allows you to view information about BGP keepalive messages.
debug ip bgp [ipv6-address | peer-group peer-group-name] keepalives [in | out]
To disable debugging, use the no debug ip bgp [ip-address | peer-group peer-group-name]
keepalives [in | out] command.
ipv6-address
peer-group
peer-group-name
in
out
EXEC Privilege
Version 8.4.2.1
Introduced on C-Series and S4810.
Version 8.2.1.0
Introduced on E-Series ExaScale
Version 7.4.1.0
Introduced on E-Series TeraScale
Enter the
no debug ip bgp
command to remove all configured debug commands for BGP.
Allows you to view information about BGP notifications received from neighbors.
debug ip bgp [ipv6-address | peer-group peer-group-name] notifications [in | out]
(OPTIONAL) Enter the IPv6 address in the
/x
by the prefix length in the
format.
Range: /0 to /128
::
The
notation specifies successive hexadecimal fields of zeros.
(OPTIONAL) Enter the keyword
of the peer group.
(OPTIONAL) Enter the keyword
messages.
(OPTIONAL) Enter the keyword
messages.
x:x:x:x::x
format followed
peer-group
followed by the name
in
to view only inbound keepalive
out
to view only outbound keepalive
Advertisement
