Advertisement
ROUTER RIP Mode
ROUTER ISIS Mode
ROUTER BGP Mode
Determining the Chassis Mode
26
|
CLI Basics
Use the ROUTER RIP mode to configure RIP on the C-Series or E-Series, as described in
Router Information Protocol
To enter ROUTER RIP mode:
1. Verify that you are logged into the CONFIGURATION mode.
2. Enter the router rip command.The prompt changes to include (conf-router_rip).
You can switch to the INTERFACE mode by using the interface command or you can switch to the
ROUTER OSPF mode by using the router ospf command.
Use the ROUTER ISIS mode to configure ISIS on the E-Series, as described in
Intermediate System
(IS-IS).
To enter ROUTER ISIS mode:
1. Verify that you are logged into the CONFIGURATION mode.
2. Enter the router isis [tag] command.The prompt changes to include (conf-router_isis).
You can switch to the INTERFACE mode by using the interface command or you can switch to the
ROUTER RIP mode by using the router rip command.
Use the ROUTER BGP mode to configure BGP on the C-Series or E-Series, as described in
Chapter 12, Border Gateway Protocol IPv4
To enter ROUTER BGP mode:
1. Verify that you are logged into the CONFIGURATION mode.
2. Enter the router bgp as-number command.The prompt changes to include (conf-router_bgp).
You can return to the CONFIGURATION mode by entering the exit command.
The chassis mode in FTOS determines which hardware is being supported in an E-Series chassis. The
chassis mode is programmed into an EEPROM on the backplane of the chassis and the change takes
place only after the chassis is rebooted. Configuring the appropriate chassis mode enables the system
to use all the ports on the card and recognize all software features.
(RIP).
(BGPv4).
Chapter 48,
Intermediate System to
Advertisement
