Dell Force10 TeraScale E Series Reference Manual page 751

multicast
soft
in
out
Command Modes
EXEC Privilege
Command
Version 8.4.2.1
History
Version 8.2.1.0
Version 7.4.1.0
clear ip bgp peer-group
Reset a peer-group's BGP sessions.
c e
Syntax clear ip bgp peer-group peer-group-name
Parameters
peer-group-name
Command Modes EXEC Privilege
Command
Version 8.4.2.1
History
Version 8.2.1.0
Version 7.4.1.0
clear ip bgp ipv6 dampening
Clear information on route dampening and return suppressed route to active state.
c e
Syntax clear ip bgp ipv6 unicast dampening [ipv6-address]
Parameters
ipv6-address
Command Modes EXEC Privilege
Command
Version 8.4.2.1
History
(OPTIONAL) Enter the keyword
within the selected address family.
Multicast is supported on IPv4 only
(OPTIONAL) Enter the keyword
without resetting the BGP TCP session, that is, BGP Soft Reconfiguration.
Note:
If you enter
outbound policies are reset.
(OPTIONAL) Enter the keyword
(OPTIONAL) Enter the keyword
Introduced on C-Series and S4810.
Introduced on E-Series ExaScale
Introduced on E-Series TeraScale
Enter the peer group name to reset the BGP sessions within that peer group.
Introduced on C-Series and S4810.
Introduced on E-Series ExaScale
Introduced on E-Series TeraScale
Enter the IPv6 address in the
/x
the format.
Range: /0 to /128
::
The notation specifies successive hexadecimal fields of zeros
Introduced on C-Series and S4810.
multicast
to select the multicast option
soft
to configure and activate policies
clear ip bgp ip6-address soft
in
to activate only inbound policies.
out
to activate only outbound policies.
x:x:x:x::x
format followed by the prefix length in
IPv6 Border Gateway Protocol (IPv6 BGP) | 751
, both inbound and