Advertisement
Usage
Information
Command
History
bgp bestpath router-id ignore
c e s
Syntax
Defaults
Command Modes
Usage
Information
Command
History
bgp client-to-client reflection
c e s
Syntax
Defaults
Command Modes
Usage
Information
Related
Commands
Command
History
322
|
Border Gateway Protocol IPv4 (BGPv4)
The MED is a 4-Byte unsigned integer value and the default behavior is to assume a missing MED as
4294967295. This command causes a missing MED to be treated as 0. During the path selection, paths
with a lower MED are preferred over those with a higher MED.
Version 7.8.1.0
Introduced support on S-Series
Version 7.7.1.0
Introduced support on C-Series
Version 6.3.1.0
Introduced
Do not compare router-id information for external paths during best path selection.
bgp bestpath router-id ignore
To return to the default selection, use the no bgp bestpath router-id ignore command.
Disabled
ROUTER BGP
Configuring this option will retain the current best-path. When the session is subsequently reset, the
oldest received path will be chosen as the best-path.
Version 8.3.1.0
Introduced
Enables you to enable route reflection between clients in a cluster.
bgp client-to-client reflection
To disable client-to-client reflection, enter no bgp client-to-client reflection.
Enabled when a route reflector is configured.
ROUTER BGP
Route reflection to clients is not necessary if all client routers are fully meshed.
bgp cluster-id
neighbor route-reflector-client
Version 7.8.1.0
Introduced support on S-Series
Version 7.7.1.0
Introduced support on C-Series
Assign ID to a BGP cluster with two or more route reflectors.
Configure a route reflector and clients.
Advertisement
