Advertisement
Defaults
The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes
CONFIGURATION
Command
Version 8.2.1.0
History
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series original Command
Related
telnet
Commands
ip tftp source-interface
c e s
Assign an interface's IP address in outgoing packets for TFTP traffic.
Syntax
ip tftp source-interface interface
Parameters
interface
Defaults
The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes
CONFIGURATION
Command
Version 8.2.1.0
History
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series original Command
Increased number of VLANs on ExaScale to 4094 (was 2094)
Introduced on E-Series ExaScale
Support added for S-Series
Introduced on C-Series
Telnet to another device.
Enter the following keywords and slot/port or number information:
•
For an 100/1000 Ethernet interface, enter the keyword
the slot/port information.
•
For a 1-Gigabit Ethernet interface, enter the keyword
slot/port information.
•
For Loopback interfaces, enter the keyword
(0) to 16383.
•
For a Port Channel, enter the keyword
C-Series and S-Series: 1-128
E-Series: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale
•
For the SONET interfaces, enter the keyword
•
For a 10-Gigabit Ethernet interface, enter the keyword
by the slot/port information.
•
For a VLAN interface, enter the keyword
Increased number of VLANs on ExaScale to 4094 (was 2094)
Introduced on E-Series ExaScale
Support added for S-Series
Introduced on C-Series
GigabitEthernet
GigabitEthernet
loopback
followed by a number from zero
port-channel
followed by a number:
sonet
followed by slot/port information.
TenGigabitEthernet
vlan
followed by a number from 1 to 4094.
Control and Monitoring | 91
followed by
followed by the
followed
Advertisement
