Advertisement
line
c e s
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
Related
Commands
linecard
c e
Syntax
Parameters
Defaults
Command Modes
92
|
Control and Monitoring
Enable and configure console and virtual terminal lines to the system. This command accesses LINE
mode, where you can set the access conditions for the designated line.
line {aux 0 | console 0 | vty number [end-number]}
aux 0
Enter the keyword
Note: This option is supported on E-Series only.
console 0
Enter the keyword
The console option for the S-Series is <0-0>.
vty number
Enter the keyword
line for Telnet sessions.
The system supports 10 Telnet sessions.
end-number
(OPTIONAL) Enter a number from 1 to 9 as the last virtual terminal line to configure.
You can configure multiple lines at one time.
Not configured
CONFIGURATION
Version 8.1.1.0
Introduced on E-Series ExaScale
Version 7.6.1.0
Introduced on S-Series
Version 7.5.1.0
Introduced on C-Series
E-Series original Command
You cannot delete a terminal connection.
access-class
Restrict incoming connections to a particular IP address in an IP access control list (ACL).
password
Specify a password for users on terminal lines.
show linecard
Display the line card(s) status.
Pre-configure a line card in a currently empty slot of the system or a different line card type for the slot.
linecard number card-type
number
Enter the number of the slot.
C-Series Range: 0-7
E-Series Range: 0 to 13 on a E1200/E1200i, 0 to 6 on a E600/E6001, and 0 to 5 on a E300.
card-type
Enter the line card ID (see the Supported Hardware section in the Release Notes).
Not configured
CONFIGURATION
aux 0
to configure the auxiliary terminal connection.
console 0
to configure the console port.
vty
followed by a number from 0 to 9 to configure a virtual terminal
Advertisement
