Advertisement
test-condition (comparing samples)
c e
Syntax
Parameters
Defaults
Command Mode
Command
History
Usage
Information
518
|
FTOS Service Agent
Configure an action to collect and compare multiple samples of a statistic.
test-condition statistic operator sample {cpu | rpm-any} number
test-condition statistic
operator
sample number
cpu
rpm-any
|
None
CALL-HOME TEST-LIST
Version 8.2.1.0
Removed
Version 7.8.1.0
Introduced on C-Series and E-Series
FTSA avoids false triggers when a counter rolls over by ignoring the first sample taken after a rollover.
Also, FTSA does not allow you to configure a test that makes no sense because of a comparator that is
out of range. For example, by entering cpu-5-min increase number 150, you would be
looking for a difference between two CPU percentage utilization samples of at least 150. 150 is not
possible, because percentage utilization can only go up to 100, so FTSA displays the acceptable range,
as shown below, and will issue an error message if you try to enter a value that is out of range.
test-condition
Enter the keyword
statistic request types:
cpu-1-min
•
: Average CPU utilization for 1 minute
cpu-5-min
•
: Average CPU utilization for 5 minutes
interface-bit-rate
input | output
•
{
on a given line card
interface-crc interface:
•
interface-rate
input | output
•
{
given interface
interface-throttles interface
•
memory-free
•
: Free system memory
memory-free-percent
•
memory-used
•
: System memory used
memory-used-percent
•
wred-drops interface
•
(E-Series only)
Enter one of the following Boolean comparison operators:
equal-to, greater-than, increase, less-than, not-equal-to,
no-change
.
sample
Enter the keyword
, followed by an integer representing the
number of the sample collected. For example, 5 is the fifth sample collected,
so the first and fifth samples would be compared, using the designated
operator.
Range: 2–100
Default: 2
Enter the processor that will be tested: cp, lp, rp1, rp2, or test all RPM CPUs
rpm-any
with the keyword
message-text
keyword. Added operators.
, followed by one of the following
slot#
}
: Instantaneous bit rate
Number of CRC errors on a given interface
interface
}
: Packet rate on a
: Number of throttles on an interface
: Free system memory free in percentage
: System memory used in percentage
: Number of WRED drops on an interface
decrease,
.
Advertisement
