Advertisement
order
monitor
Defaults
Not configured.
Command Modes
CONFIGURATION-EXTENDED-ACCESS-LIST
Command
Version 8.2.1.0
History
Version 8.1.1.0
Version 7.4.1.0
Version 6.5.10
Usage
The monitor option is relevant in the context of the flow-based monitoring feature only. See
Information
Chapter 44, Port
When you use the log option, CP processor logs details about the packets that match. Depending on
how many packets match the log entry and at what rate, the CP may become busy as it has to log these
packets' details.
The order option is relevant in the context of the Policy QoS feature only. The following applies:
•
•
•
•
•
You cannot include IP, TCP or UDP (Layer 3) filters in an ACL configured with ARP or Ether-type
(Layer 2) filters. Apply Layer 2 filters to interfaces in Layer 2 mode.
Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Introduced on E-Series ExaScale
monitor
Added
Expanded to include the optional QoS
Monitoring.
The seq sequence-number is applicable only in an ACL group.
The order option works across ACL groups that have been applied on an interface via QoS policy
framework.
The order option takes precedence over the seq sequence-number.
If sequence-number is not configured, then rules with the same order value are ordered
according to their configuration order.
If the sequence-number is configured, then the sequence-number is used as a tie breaker for
rules with the same order.
Note:
When ACL logging and byte counters are configured simultaneously, byte counters
may display an incorrect value. Configure packet counters with logging instead.
(OPTIONAL) Enter the keyword
ACL entry.
Range:
0 to 254 (where 0 is the highest priority and 254 is the lowest;
lower order numbers have a higher priority)
Default:
If the order keyword is not used, the ACLs have the lowest order
by default (255).
(OPTIONAL) Enter the keyword
traffic that you want to monitor and the ACL in which you are creating the rule
will be applied to the monitored interface. For details, see the section
"Flow-based Monitoring" in the Port Monitoring chapter of the FTOS
Configuration Guide.
option
order
order
to specify the QoS priority for the
monitor
when the rule is describing the
priority for the ACL entry.
Access Control Lists (ACL) | 247
Advertisement
