Advertisement
Related
interface vlan
Commands
tagged
untagged
c e s
Add a Layer 2 interface to a VLAN as an untagged interface.
Syntax
untagged interface
To remove an untagged interface from a VLAN, use the no untagged interface command.
Parameters
interface
Defaults
All interfaces in Layer 2 mode are untagged.
Command Modes
INTERFACE VLAN
Command
Version 7.6.1.0
History
Version 7.5.1.0
pre-Version 6.2.1.1
Usage
Untagged interfaces can only belong to one VLAN.
Information
In the Default VLAN, you cannot use the no untagged interface command. To remove an untagged
interface from all VLANs, including the Default VLAN, enter the INTERFACE mode and use the
switchport
Related
interface vlan
Commands
tagged
Configure a VLAN.
Specify which interfaces in a VLAN are tagged.
Enter the following keywords and slot/port or number information:
•
For a 1-Gigabit Ethernet interface, enter the keyword
the slot/port information.
•
For a Port Channel interface, enter the keyword
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
•
For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
command.
Configure a VLAN.
Specify which interfaces in a VLAN are tagged.
GigabitEthernet
followed by
port-channel
followed by a
TenGigabitEthernet
no
Layer 2 | 895
Advertisement
