Advertisement
Usage
For information on the specific trap sent and the corresponding Syslog refer to
Information
mac-address-table station-move time-interval
e
Reduce the amount of time FTOS takes to detect aged entries and station moves.
Syntax
[no] mac-address-table station-move time-interval number
Parameters
time-interval number
Defaults
5000ms
Command Modes
CONFIGURATION
Command
Version 7.8.1.0
History
Usage
FTOS takes 4 to 5 seconds to detect aged entries and station moves because the MAC address table
Information
scanning routine runs every 5000 ms by default. To achieve faster detection, reduce the scanning
interval.
mac-address-table station-move refresh-arp
c e s
Ensure that ARP refreshes the egress interface when a station move occurs due to a topology change.
Syntax
[no] mac-address-table station-move refresh-arp
Defaults
No default values or behavior
Command Modes
CONFIGURATION
Command
Version 7.7.1.0
History
Version 7.6.1.0
Version 7.4.1.0
Usage
See the "NIC Teaming" section of the Layer 2 chapter in the FTOS Configuration Guide for details on
Information
using this command.
Select the interval of the successive scans of the MAC address table that are
used to detect a aged entries and station moves.
Range: 500 to 5000ms
Introduced on E-Series
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
Appendix ,
.
Layer 2 | 871
Advertisement
