Advertisement
show interfaces dampening
c e s
Syntax
Parameters
Defaults
Command Modes
Command
History
Example
FTOS#show interfaces dampening
Interface
Gi 3/2
Gi 3/10
FTOS#
Related
Commands
598
|
Interfaces
interface dampening information.
Display
show interfaces dampening [[interface] [summary] [detail]]
interface
summary
detail
No default values or behavior
EXEC
Version 8.1.1.0
Introduced on E-Series ExaScale
Version 7.6.1.0
Introduced on S-Series
Version 7.5.1.0
Introduced on C-Series
Version 7.4.1.0
Introduced
Figure 23-33. show interfaces dampening Command Example
Supp
Flaps
State
Up
0
Up
0
dampening
show interfaces
show interfaces configured
(Optional) Enter one of the following keywords and slot/port or number
information:
•
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
•
For a Port Channel interface, enter the keyword
followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
•
For a SONET interface, enter the keyword
port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
(OPTIONAL) Enter the keyword
summary of dampening data, including the number of interfaces configured
and the number of interfaces suppressed, if any.
(OPTIONAL) Enter the keyword
dampening data.
Penalty
Half-Life
0
20
0
5
Configure dampening on an interface
Display information on a specific physical interface or virtual interface.
Display any interface with a non-default configuration.
port-channel
sonet
followed by the slot/
followed by the slot/port information.
summary
to display the current
detail
to display detailed interface
Reuse
Suppress
800
4500
750
2500
Max-Sup
120
20
Advertisement
