Advertisement
Parameters
file-url
Command Modes
EXEC Privilege
Command
Version 8.4.1.0
History
Version 8.2.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series original Command
Usage
FTOS supports a maximum of 100 files, at the root directory level, on both the internal and external
Information
Flash.
The usbflash and rpm0usbflash commands are supported on E-Series ExaScale platform only.
Refer to the FTOS Release Notes for a list of approved USB vendors.
When copying a file to a remote location (for example, using Secure Copy (SCP)), enter only the
keywords and FTOS prompts you for the rest of the information.
For example, when using SCP, you can enter copy running-config scp:
The running-config is the source, and the target is specified in the ensuing prompts. FTOS prompts
you to enter any required information, as needed for the named destination—remote destination,
destination filename, user ID and password, etc.
When you use the copy running-config startup-config command to copy the running
configuration (the startup configuration file amended by any configuration changes made since the
system was started) to the startup configuration file, FTOS creates a backup file on the internal flash of
the startup configuration.
FTOS supports copying the running-configuration to a TFTP server or to an FTP server:
copy running-config tftp:
Enter the following location keywords and information:
•
To copy a file from the internal FLASH, enter
•
To copy a file on an FTP server, enter
•
To copy a file from the internal FLASH on RPM0, enter
•
To copy a file from the external FLASH on RPM0, enter
•
To copy a file from the internal FLASH on RPM1, enter
•
To copy a file from the external FLASH on RPM1, enter
•
To copy the running configuration, enter the keyword
•
To copy the startup configuration, enter the keyword
•
To copy using Secure Copy (SCP), enter the keyword
source position, then enter the target URL;
scp:
If
is entered in the target position, first enter the source URL; see below for
examples.)
•
To copy a file on the external FLASH, enter
•
To copy a file on a TFTP server, enter
ExaScale only
•
To copy a file from a USB drive on RPM0, enter
•
To copy a file from an external USB drive, enter
Added IPv6 addressing support for FTP, TFTP, and SCP.
usbflash
Added
and
Introduced on S-Series and added SSH port number to SCP prompt sequence on all
systems.
Introduced on C-Series
flash://
ftp://user:password
running-config
startup-config
scp:
slot0://
followed by the filename.
tftp://hostip/filepath
rpm0usbflash://filepath
usbflash://filepath
rpm0usbflash
commands on E-Series ExaScale
followed by the filename.
hostip/filepath
@
rpm0flash://filepath
rpm0slot0://filepath
rpm1flash:/
filepath
/
rpm1slot0://filepath
.
.
scp:
(If
is entered in the
File Management | 33
Advertisement
