Advertisement
debug isis update-packets
e
Syntax
Parameters
Command Modes
default-information originate
e
Syntax
Parameters
Defaults
Command Modes
Command
History
826
|
Intermediate System to Intermediate System (IS-IS)
Enable debugging on Link State PDUs (LSPs)
debug isis update-packets [interface]
To turn off debugging, enter the no debug isis update-packets [interface] command.
interface
(OPTIONAL) Identifies the interface type slot/port as one of the following:
•
For a 1-Gigabit Ethernet interface, enter the keyword
by the slot/port information.
•
For a Port Channel interface, enter the keyword
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
•
For a SONET interface, enter the keyword
information.
•
For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
•
For a VLAN, enter the keyword
EXEC Privilege
Generate a default route into an IS-IS routing domain and controls the distribution of default
information.
default-information originate [always] [metric metric] [route-map map-name]
To disable the generation of a default route into the specified IS-IS routing domain, enter the no
default-information originate [always] [metric metric] [route-map map-name] command.
always
(OPTIONAL) Enter the keyword
advertised
metric metric
(OPTIONAL) Enter the keyword
route.
Range: 0 to 16777215
route-map
(OPTIONAL) A default route will be generated by the routing process if the route
map is satisfied.
map-name
Not configured.
ROUTER ISIS (for IPv4)
CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Version 7.5.1.0
Introduced IPv6 ISIS support
Version 6.3.1.0
Introduced
that are detected by a router.
GigabitEthernet
port-channel
sonet
followed by the slot/port
TenGigabitEthernet
vlan
followed by a number from 1 to 4094.
always
to have the default route always
metric
followed by a number to assign to the
followed
followed by a
Advertisement
