Advertisement
Layer 2
Overview
This chapter describes commands to configure Layer 2 features. It contains the following sections:
•
•
Some MAC addressing commands are supported only on the E-Series, some on all three Dell Force10
platforms and some on two Dell Force10 platforms. Support is indicated by these characters, where
appropriate, under each command heading:
The VLAN commands are supported on all three Dell Force10 platforms —
MAC Addressing Commands
The following commands are related to configuring, managing, and viewing MAC addresses:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
MAC Addressing Commands
Virtual LAN (VLAN) Commands
clear mac-address-table dynamic
mac accounting destination
mac-address-table aging-time
mac-address-table static
mac-address-table station-move threshold
mac-address-table station-move time-interval
mac-address-table station-move refresh-arp
mac cam fib-partition
mac learning-limit
mac learning-limit learn-limit-violation
mac learning-limit station-move-violation
mac learning-limit reset
show cam mac linecard (count)
show cam maccheck linecard
show cam mac linecard (dynamic or static)
show cam mac stack-unit
show mac-address-table
show mac-address-table aging-time
show mac accounting destination
show mac cam
c e s
30
c e s
Layer 2 | 867
Advertisement
