Advertisement
boot change
c es
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
60
|
BOOT_USER Mode
•
show bootvar
•
show default-gateway
•
show interface management ethernet
Note:
You cannot use the Tab key to complete commands in this mode.
Note:
The question mark (?) key to get help does not work in this mode. Instead, enter help.
Change the primary, secondary, or default FTOS boot configuration.
boot change {primary | secondary | default}
primary
Enter the keyword
to boot
secondary
Enter the keyword
operating system boot selection is not available.
default
Enter the keyword
operating system boot parameter selection is not available. The default location should
always be the internal flash device (flash:), and a verified image should be stored there.
Not configured.
BOOT_USER
Version 7.8.1.0
Introduced on S-Series
After entering the boot change keywords and selecting among parameters, above, press Enter. The
software prompts you to enter the following:
•
The boot device (ftp, tftp, flash, slot0) (Note: tftp and flash are the only options available for the
S-Series), image file name, IP address of the server containing the image, username and password
(only for FTP)
Note:
When you enter a new parameter that extends beyond 80 characters, you cannot use the
Backspace key to correct any mistakes. If you make a mistake, you must re-enter the
parameter.
Note:
The IP address of the designated download port must be set before you execute this
command. Otherwise, an error message will alert you that the configuration cannot proceed.
See the command
shows the first field after you enter boot change primary. At this point:
Figure 4-1
•
Press Enter to accept the information already configured, or
•
Change that information. To do so, press the . (period) key and enter new information. After you
enter the information, press Enter.
primary
to configure the boot parameters used in the first attempt
FTOS
.
secondary
to configure boot parameters used if the primary
default
to configure boot parameters used if the secondary
interface management ethernet ip
address.
Advertisement
