Advertisement
Defaults
299 seconds
Command Modes
INTERFACE
Command
Version 8.1.1.0
History
Version 7.6.1.0
Version 7.5.1.0
Version 6.1.1.0
The configured rate interval is displayed, along with the collected traffic data, in the output of show
Usage
Information
interfaces commands.
Related
show interfaces
Commands
show config
c e s
Display
show config
Syntax
Command Modes
INTERFACE
Command
Version 8.1.1.0
History
Version 7.6.1.0
Version 7.5.1.0
pre-Version 6.2.1.0
Example
Figure 23-25. show config Command Example for the INTERFACE Mode
FTOS(conf-if)#show conf
!
interface GigabitEthernet 1/7
FTOS(conf-if)#
show config (from INTERFACE RANGE mode)
c e s
Display
Syntax
show config
Command Modes
CONFIGURATION INTERFACE (conf-if-range)
Command
Version 8.1.1.0
History
Version 7.6.1.0
Introduced on E-Series ExaScale
Introduced on S-Series
Introduced on C-Series
Introduced
the interface configuration.
no ip address
switchport
no shutdown
the bulk configured interfaces
Introduced on E-Series ExaScale
Introduced on S-Series
Display information on physical and virtual interfaces.
Introduced on E-Series ExaScale
Introduced on S-Series
Introduced on C-Series
Introduced for E-Series
(interface
range).
Interfaces | 589
Advertisement
