Advertisement
BOOT_USER Mode
Overview
Most of the commands in this chapter are in Configuration mode, except for format, which is in the
BOOT_ADMIN mode. The exception to this is that on the Dell Force10 S50 platform. On the S50, the
commands are accessed from the BOOT_USER mode. Command support on Dell Force10 platforms is
indicated by the characters that appear below each command heading:
•
•
•
To access the BOOT_USER mode, boot your Dell Force10 platform.When the prompt, "
to break into BOOT_USER mode
Commands
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
c
= C-Series
e
= E-Series
s
= S-Series
boot change
boot messages
boot selection
boot zero
default-gateway
delete
dir
enable
format
ignore enable-password
ignore startup-config
interface management ethernet ip address
interface management ethernet mac-address
interface management ethernet port
interface management port config
reload
rename
restore factory-defaults
save
show boot selection
show bootflash
" appears, press a key.
4
Hit any key
BOOT_USER Mode | 59
Advertisement
