Advertisement
Command Modes
Command
History
show mac-address-table
c e s
Syntax
Parameters
880
|
Layer 2
interface interface
vlan vlan-id
EXEC
EXEC Privilege
Version 7.6.1.0
This version of the command introduced for S-Series
MAC address table..
Display the
Note:
Sticky MAC is not supported on the S25 or S50 in FTOS release 8.4.2.6.
show mac-address-table [dynamic | static] [address mac-address | interface interface |
vlan vlan-id] [count [vlan vlan-id] [interface interface-type [slot [/port]]]]
dynamic
static
address mac-address
(OPTIONAL) Enter the keyword
slot and port information:
•
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
•
For a Port Channel interface, enter the keyword
followed by a number:
S-Series Range: 1-128
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
(OPTIONAL) Enter the keyword
the MAC address assigned to the VLAN.
Range: 1 to 4094.
(OPTIONAL) Enter the keyword
addresses learned dynamically by the switch. Optionally, you can also add
address/mac-address
one of these combinations:
interface
vlan vlan-id.
, or
(OPTIONAL) Enter the keyword
specifically configured on the switch. Optionally, you can also add one of
address/mac-address
these combinations:
vlan vlan-id.
(OPTIONAL) Enter the keyword
the nn:nn:nn:nn:nn:nn format to display information on that MAC address.
interface
followed by the interface type,
port-channel
followed by the slot/port information.
vlan
followed by the VLAN ID to display
dynamic
to display only those MAC
interface/
,
static
to display only those MAC address
interface/interface
,
address
followed by a MAC address in
, or
Advertisement
