Advertisement
Table 24-3. Configurations of the load-balance Command
Configuration
Default (IP 5-tuple)
ip-selection 3-tuple
mac
ip-selection 3-tuple and mac
ip-selection packet-based
ip-selection packet-based and mac
Related
Commands
management route
c e
Syntax
Parameters
Defaults
Command Modes
Command
History
656
|
IPv4 Routing
•
IP source address
•
IP destination address
•
IP Protocol type
•
TCP/UDP source port
•
TCP/UDP destination port
Note:
For IPV6, only the first 32 bits (LSB) of IP Source Address and IP Destination
Address are used for hash generation.
lists the load balance command options and how the command combinations effect the
The table below
distribution of traffic.
Switched IP Traffic
Packet based: IPV4
No distribution: IPV6
ip address
Change the algorithm used to distribute traffic on an E-Series chassis.
Configure a static route that points to the Management interface or a forwarding router.
management route {ipv4-address | ipv6-address}/mask {forwarding-router-address |
managementethernet}
ipv4-address | ipv6-address
{
mask
forwarding-router-address
managementethernet
Not configured.
CONFIGURATION
Version 8.4.1.0
Added support for IPv6 management routes.
Version 8.1.1.0
Introduced on E-Series ExaScale
Routed IP Traffic
(IPV4 Only)
IP 5-tuple
IP 3-tuple
MAC based
MAC based
Packet based: IPV4
MAC based
Packet based: IPV4
/
Enter an IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X),
}
followed by the prefix-length for the IP address of the management
interface.
Enter an IPv4 or IPv6 address of a forwarding router.
Enter the keyword
Management interface on the Primary RPM.
Switched Non-IP
IP 5-tuple
MAC based
IP 3-tuple
MAC based
IP 5-tuple
MAC based
IP 3-tuple
MAC based
MAC based
MAC based
managementethernet
for the
Traffic
Advertisement
