Advertisement
speed (Management interface)
c e
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
Related
Commands
switchport
c e s
Syntax
Parameters
614
|
Interfaces
Set the speed for the Management interface.
speed {10 | 100 | auto}
To return to the default setting, use the no speed {10 | 100} command.
10
Enter the keyword
100
Enter the keyword
auto
Enter the keyword
auto
INTERFACE
Version 8.1.1.0
Version 7.5.1.0
pre-Version 6.2.1.0
This command is found on the Management interface only.
interface ManagementEthernet
duplex (Management)
management route
Place an interface in Layer 2 mode.
switchport [backup interface {gigabit slot/port | tengigabit slot/port | port-channel
number}]
To remove an interface from Layer 2 mode and place it in Layer 3 mode, enter no switchport. If a
switchport backup interface is configured, you must first remove the backup configuration. To remove
a switchport backup interface, enter no switchport backup interface {gigabit slot/port |
tengigabit slot/port | port-channel number}].
backup
Use this option to configure a redundant Layer 2 link without using Spanning Tree. This
keyword configures a backup port so that if the primary port fails the backup port
interface
changes to the up state. If the primary later comes up, it becomes the backup.
gigabit
Enter this keyword if the backup port is a 1G port.
tengigabit
Enter this keyword if the backup port is a 10G port.
port-channel
Enter this keyword if the backup port is a static or dynamic port channel.
slot/port
Specify the line card and port number of the backup port.
10
to set the interface's speed to 10 Mb/s.
100
to set the interface's speed to 100 Mb/s.
auto
to set the interface to auto-negotiate its speed.
Introduced on E-Series ExaScale
Introduced on C-Series
Introduced for E-Series
Configure the Management port on the system (either the Primary or
Standby RPM).
Set the mode of the Management interface.
Configure a static route that points to the Management interface or a
forwarding router.
Advertisement
