Dell Force10 TeraScale E Series Reference Manual page 645

ip domain-lookup
c e s
Enable dynamic host-name to address resolution (that is, DNS).
ip domain-lookup
Syntax
To disable DNS lookup, use the no ip domain-lookup.
Defaults Disabled.
Command Mode
CONFIGURATION
Command
Version 8.1.1.0
History
Version 7.6.1.0
Version 7.5.1.0
Usage
To fully enable DNS, also specify one or more domain name servers with the
Information
command.
FTOS does not support sending DNS queries over a VLAN. DNS queries are sent out all other
interfaces, including the Management port.
To view current bindings, use the
Related
ip name-server
Commands
show hosts
ip domain-name
c e s
Configure one domain name for the switch.
Syntax ip domain-name name
To remove the domain name, enter no ip domain-name.
Parameters
name
Defaults
Not configured.
Command Modes CONFIGURATION
Command
Version 8.1.1.0
History
Version 7.6.1.0
Version 7.5.1.0
Usage You can only configure one domain name with the
Information
one domain name, configure the
Use the following steps to enable dynamic resolution of hosts:
•
Introduced on E-Series ExaScale
Introduced on S-Series
Introduced on C-Series
Specify a DNS server.
View current bindings.
Enter one domain name to be used to complete unqualified names (that is,
incomplete domain names that cannot be resolved).
Introduced on E-Series ExaScale
Introduced on S-Series
Introduced on C-Series
specify a domain name server with the
show hosts command.
ip domain-name
ip domain-list command up to 6 times.
ip name-server
ip name-server
command. To configure more than
command.
IPv4 Routing | 645