Advertisement
Defaults
Command Mode
Command
History
ethernet oam remote-failure
s
Syntax
Parameters
Defaults
Command Mode
Command
History
ethernet oam remote-loopback
s
Syntax
Parameters
Defaults
Command Mode
Command
History
182
|
802.3ah
Active
INTERFACE
Version 8.4.1.0
Introduced on S-Series
Block or disable an interface when a particular critical link event occurs.
ethernet oam remote-failure
|
}
error-disable-interface
critical-event
dying-gasp
link-fault
error-block-interface
error-disable-interface
Disabled
INTERFACE
Version 8.4.1.0
Introduced on S-Series
Start or stop loopback operation on a local interface with a remote peer.
ethernet oam remote-loopback {
|
Start or stop a loopback operation with a remote peer.
start
stop
Specify the interface on which remote-loopback starts/stops, for example
interface interface
gigabitethernet 0/1
Enabled
EXEC Privilege
Version 8.4.1.0
Introduced on S-Series
{
critical-event
|
dying-gasp
An unspecified critical event occurred.
An unrecoverable local failure condition occurred.
A fault occurred in the receive direction of the local peer.
Block the interface if the specified fault occurs.
Disable the interface if the specified fault occurs.
|
}
start
stop
interface interface
.
|
link-fault
}
action
{
error-block-interface
Advertisement
