Advertisement
Parameters
group-address
interface
Defaults
Disabled
Command Modes
EXEC Privilege
Command
Version 7.6.1.0
History
Version 7.5.1.0
E-Series legacy command
Usage
IGMP commands accept only non-VLAN interfaces—specifying a VLAN will not yield results. This
Information
command displays packets for IGMP and IGMP Snooping.
ip igmp access-group
c e s
Use this feature to specify access control for packets.
Syntax
ip igmp access-group access-list
To remove the feature, use the no ip igmp access-group access-list command.
Parameters
access-list
Defaults
Not configured
Command Modes
INTERFACE (conf-if-interface-slot/port)
Command
Version 7.8.1.0
History
Version 7.6.1.0
Usage
The access list accepted is an extended ACL. This feature is used to block IGMP reports from hosts, on
Information
a per-interface basis; based on the group address and source address specified in the access list.
(OPTIONAL) Enter the IP multicast group address in dotted decimal format.
(OPTIONAL) Enter the following keywords and slot/port or number information:
Introduced on S-Series
Introduced on C-Series
Enter the name of the extended ACL (16 characters maximum).
Introduced on C-Series and S-Series
Introduced on E-Series
Internet Group Management Protocol (IGMP) | 547
Advertisement
