Advertisement
Parameters
Defaults
Command Mode
Command
History
Usage
Information
Examples
Related
Commands
520
|
FTOS Service Agent
test-condition statistic
operator
number value
cpu
rpm-any
|
None
CALL-HOME TEST-LIST
Version 8.2.1.0
Removed
Version 7.8.1.0
Introduced on C-Series and E-Series
FTOS does not allow you to configure a test that makes no sense, such as cpu-5-min greater-than
number 150. CPU percentage utilization can only go up to 100, so 150 is not possible. FTOS
displays the acceptable range, as shown below
FTOS(conf-callhome-testlist-test)#test-condition cpu-5-min greater-than ?
number
FTOS(conf-callhome-testlist-test)#test-condition cpu-5-min greater-than number ?
<0-100>
FTOS(conf-callhome-testlist-test)#test-condition cpu-5-min greater-than number 10
This example shows a couple other keyword configuration examples.
FTOS(conf-call-home-testlist-test)# test-condition interface-rate input 1 less-than
number 98
FTOS(conf-call-home-testlist-test)# test-condition memory-used not-equal-to number
1000
dampen
test-limit
test-condition
Enter the keyword
statistic request types:
cpu-1-min
: Average CPU utilization for 1 minute
cpu-5-min
: Average CPU utilization for 5 minutes
interface-bit-rate
on a given line card
interface-crc interface:
interface-rate interface
interface-throttles interface
memory-free
: Free system memory
memory-free-percent
memory-used
: System memory used
memory-used-percent
wred-drops interface
(E-Series only)
Enter one of the following Boolean comparison operators:
equal-to, greater-than, increase, less-than, not-equal-to,
no-change
.
number
Enter the keyword
value to the designated statistic, in the range pertinent to the statistic.
Enter the processor that will be tested: cp, lp, rp1, rp2, or test all RPM CPUs
rpm-any
with the keyword
message-text
keyword. Added operators.
The boolean comparison value
Enter the boolean comparison value
Set a delay before sampling for a test condition again after it has been matched.
Set the number of times that the test list that should be executed.
, followed by one of the following
input | output
slot#
{
}
: Instantaneous bit rate
Number of CRC errors on a given interface
: Packet rate on a given interface
: Number of throttles on an interface
: Free system memory free in percentage
: System memory used in percentage
: Number of WRED drops on an interface
, followed by an integer to be the comparison
.
decrease,
Advertisement
