Advertisement
default-test
c e
Invoke one of three preset system-monitoring test groups.
Syntax
default-test {hardware | software | exception}
Parameters
hardware
software
exception
Defaults
None
Command Mode
CALL-HOME TEST-LIST
Command
Version 7.7.1.0
History
Usage
Executing the policy-test-list command puts you in the config-callhome-testlist mode, where you
Information
use this command to invoke one of three possible test groups. FTOS monitors the system for any event
in the selected test group. If such an event occurs, FTOS invokes the action you define using the
default-action command.
Related
default-action
Commands
policy-test-list
description
c e
Enter a description for the Call Home mode.
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
description
Defaults
None
Command Modes
CONFIGURATION-CALLHOME
Command
pre-7.7.1.0
History
Related
call-home
Commands
hardware
Enter the keyword
Configuration Guide for the list of conditions monitored by this keyword.
software
Enter the keyword
Guide for the list of conditions monitored by this keyword.
exception
Enter the keyword
Configuration Guide for the list of conditions monitored by this keyword.
Introduced on C-Series and E-Series
Select the information collection action that matches the selected test group.
Name a new or existing test list and enter the config-callhome-testlist-name mode.
Enter a description to identify the Call Home mode(80 characters maximum).
Introduced
Enter the Call Home mode on the switch.
to monitor hardware conditions. See the FTOS
to monitor software conditions. See the FTOS Configuration
to monitor the exceptions events. See the FTOS
FTOS Service Agent | 503
Advertisement
