Siemens Simovert Masterdrives Compendium page 452

Communication / PROFIBUS
8.2.10.3 Evaluating CBP diagnostic parameters
NOTE
CBP diagnostic
parameters r732
8.2-122
(For CBP2 diagnostic parameters, see section 8.2.10.6)
Please note that, for types of unit with the older function classes FC
(CU1), VC (CU2) and SC (CU3), indexed parameter r731.i is to be
used appropriately instead of r732.i
In order to support start-up and for service purposes, the CBP stores
diagnostic information in a diagnostics buffer. The diagnostic information
can be read out with the indexed parameter r732.i (CB/TB diagnosis).
If two CBPs are inserted in the electronics box, the diagnostic area for
the second CBP begins in parameter r732 from index 33, i.e. an offset of
32 has to be added to the required index number for reading out the
diagnostic information of the second CBP.
Meaning
CBP_Status
DP Ctrler_Status
Global_Controls
Counter: telegrams received without faults (only DP
standard)
Reserved
Counter "TIMEOUT"
Reserved
Counter "CLEAR DATA"
Reserved
NOTICE!
The following indices have a different meaning if
"Extended telegram diagnosis" is selected via P711
P711 / P696 (CB parameter 1).
Counter: Heartbeat-counter fault
Reserved
Number of bytes for special diagnosis
Reserved
Mirroring slot Identifier 2
Mirroring slot Identifier 3
Mirroring P918 (CB bus address), only low part
Reserved
Counter re-configuration by CU
Counter initializations
Fault detection DPS manager fault (8 bits)
6SE7087-6QX70 (Version AK)
Compendium Motion Control
09.2008
Index number
1st CBP 2nd CBP
.1 .33
.2 .34
.3 .35
.4 (Low) .36 (Low)
.4 (High) .36 (High)
.5 (Low) .37 (Low)
.5 (High) .37 (High)
.6 (Low) .38 (Low)
.6 (High) .38 (High)
.7 (Low) .39 (Low)
.7 (High) .39 (High)
.8 (Low) .40 (Low)
.8 (High) .40 (High)
.9 (Low) .41 (Low)
.9 (High) .41 (High)
.10 (Low) .42 (Low)
.10 (High) .42 (High)
.11 (Low) .43 (Low)
.11 (High) .43 (High)
.12 (Low) .44 (Low)
Siemens AG
SIMOVERT MASTERDRIVES