Siemens Simovert Masterdrives Compendium page 169

Parameterizing Steps
P053 = 6
P060 = 2
P366 = ?
P970 = 0
Unit carries out parameter
reset and then leaves the
"Fixed settings" menu.
6-4
Parameter number
P053
P696
P700
P701
P702
P703
P704
Table 6-3 The factory setting is made via interface SCB2: Parameters that are not
changed by the factory setting either. None of the indices of the
parameters is changed.
Parameter number
P053
P711 to P721
P722
P918
Table 6-4 The factory setting is made either via interface 1.CB/TB or 2.CB/TB:
Parameters that are not changed by the factory setting either. None of
the indices of the parameters is changed.
Grant parameter access
6: Parameter changes permitted via PMU and serial interface
SCom1 (OP1S and PC)
Select "Fixed settings" menu
Select desired factory setting
0: Standard
Note: This parameter was correctly set prior to delivery of
the unit and only needs to be changed in exceptional
cases.
Start parameter reset
0: Parameter reset
1: No parameter change
Fig. 6-2 Sequence for parameter reset to factory setting
Parameter name
Parameterization enable
SCB protocol
SST bus address
SST baud rate
SST PKW number
SST PZD number
SST frame failure
Parameter name
Parameterization enable
CB parameters 1 to 11
CB/TB frame failure
CB bus address
6SE7087-6QX70 (Version AN)
Compendium Motion Control
08.2012
Siemens AG
SIMOVERT MASTERDRIVES