Siemens Simovert Masterdrives Compendium page 135

03.2010
5.4.2 Connecting, run-up
5.4.2.1 Connecting
Connection via
cable
    
   
  
  
Fault
Run
I
O
P
USS-Bus
Jog 7 8 9
4 5 6
1 2 3
0 +/- Reset
OP1S
5
9
4
8
3
7
2
6
1
OP1S side:
9-pole SUB-D socket
Plugging into units
of the Compact and
chassis type
Plugging onto
Compact PLUS
rectifier unit
Siemens AG 6SE7087-6QX70 (Version AL)
SIMOVERT MASTERDRIVES
The OP1S can be connected to the units in the following ways:
♦ Connection via 3 m or 5 m cable (e.g. as a hand-held input device
for start-up)
♦ Connection via cable and adapter for installation in a cabinet door
♦ Plugging into MASTERDRIVES Compact units (for point-to-point
linking or bus configuration)
♦ Plugging into MASTERDRIVES Compact PLUS units (for bus
configuration)
The cable is plugged into the Sub D socket X103 on units of the
Compact PLUS type and into Sub D socket X300 on units of the
Compact and chassis type.
Connecting cable
5
4
3
2
1
Unit side:
9-pole SUB-D connector
Fig. 5-5 Example: The OP1S in a point-to-point link with the Compact PLUS unit
Carefully penetrate the pre-punched holes for the fixing screws in the
front panel of the Compact units. Plug the OP1S onto the Sub D socket
X300 and screw it tight using the two screws (M5 x 10, accessory pack)
from the inside of the front panel.
On the Compact PLUS rectifier unit, you can plug the OP1S onto the
Sub D socket X320 and lock it in place on the front cover.
Compendium Motion Control
9
8
7
6
Parameterization
S IE ME NS
P
A
S1
X101 B
X103 C
5-13