Siemens Simovert Masterdrives Compendium page 130

Parameterization
Key Significance
ON key
OFF key
Reversing key
Toggle key
Raise key
Lower key
Hold toggle key
and depress raise
key
Hold toggle key
and depress lower
key
5-8
•
For energizing the drive (enabling motor activation).
• If there is a fault: For returning to fault display
•
For de-energizing the drive by means of OFF1, OFF2 or OFF3
(P554 to 560) depending on parameterization.
• For reversing the direction of rotation of the drive.
The function must be enabled by P571 and P572
•
For switching between parameter number, parameter index
and parameter value in the sequence indicated (command
becomes effective when the key is released).
•
If fault display is active: For acknowledging the fault
For increasing the displayed value:
•
Short press = single-step increase
•
Long press = rapid increase
For lowering the displayed value:
•
Short press = single-step decrease
•
Long press = rapid decrease
•
If parameter number level is active: For jumping back and forth
between the last selected parameter number and the
operating display (r000)
• If fault display is active: For switching over to parameter
number level
•
If parameter value level is active: For shifting the displayed
value one digit to the right if parameter value cannot be
displayed with 4 figures (left-hand figure flashes if there are
any further invisible figures to the left)
•
If parameter number level is active: For jumping directly to the
operating display (r000)
• If parameter value level is active: For shifting the displayed
value one digit to the left if parameter value cannot be
displayed with 4 figures (right-hand figure flashes if there are
any further invisible figures to the right)
Table 5-7 Operator control elements on the PMU
Function
6SE7087-6QX70 (Version AL)
Compendium Motion Control
03.2010
Siemens AG
SIMOVERT MASTERDRIVES