Siemens Simovert Masterdrives Compendium page 196

08.2012
Function diagram
modules
Siemens AG 6SE7087-6QX70 (Version AN)
SIMOVERT MASTERDRIVES
Function diagram modules (function diagrams) are shown on the
following pages for the parameter modules stored in the unit software.
There is a module on every page beginning at the top for each of the
following:
♦ Setpoint and command source,
♦ Control type and
♦ Motor encoder or the relevant sensor board (SBx)
Cutting lines have been marked in between the individual function
diagram modules to enable the modules to be separated and then
individually combined, i.e. you can create a function diagram to exactly
fit the selected combination of parameter modules. This will give you an
overview of the functionality parameterized in the units and of the
necessary assignment of the terminals.
The function parameters and visualization parameters specified in the
function diagrams are automatically adopted in the user menu and can
be visualized or changed there.
Compendium Motion Control
Parameterizing Steps
6-31