Siemens Simovert Masterdrives Compendium page 379

09.2008
Bus connectors
Order No.
Appearance
PG socket
Max. baud rate
Terminating resistor
Outgoing cable
Interfaces
•
PROFIBUS nodes
•
PROFIBUS cable
Connectable diameter of
PROFIBUS cable
Recommended for
•
IM 308-B
•
IM 308-C
•
S5-95U
•
S7-300
•
S7-400
•
M7-300
•
M7-400
•
CBP
*) NOTE
Siemens AG 6SE7087-6QX70 (Version AK)
SIMOVERT MASTERDRIVES
You need bus connectors in order to connect the PROFIBUS to a CBP.
There are different types of bus connector with degree of protection IP20.
Their different uses are shown in the table below.
6ES7 972-0BA11-0XA0
6ES7 972-0BB11-0XA0
0BA11: no
0BB11: yes
12 Mbaud
Can be connected as required
Vertical
•
9-pole Sub-D socket
•
4 terminal blocks for wires up
2
to 1.5 mm
8 ± 0.5 mm
Table 8.2-11 Structure and application of bus connectors with IP20 protection
– These connectors must not be inserted in slots E and G on Compact
units.
– If these connectors are used on CompactPLUS units contour faults
may occur on slots A and B.
(See board description in Section "Connecting-up", Fig. "PROFIBUS
connector".)
Further ordering details and descriptions as well as additional connector
types are available in the A&D AS catalog "Industrial Communication" IK
10 (Order No. E86060-K6710-A101-A6).
Compendium Motion Control
6ES7 972-0BA40-0XA0
6ES7 972-0BB40-0XA0
Can be connected as required
•
9-pole Sub-D socket
•
4 terminal blocks for wires up
to 1.5 mm
*)
Communication / PROFIBUS
0BA40: no
0BB40: yes
12 Mbaud
slanting
2
8 ± 0.5 mm
8.2-49