Siemens Simovert Masterdrives Compendium page 286

09.2008
Status after
booting
Technology release
F01
Power Extension
enable F02
Parameterizing
Siemens AG 6SE7087-6QX70 (Version AK)
SIMOVERT MASTERDRIVES
If the parameter structure between the firmware status before
booting and the new firmware has not changed, then the units
retain the same operating status (e.g. °009 ready for operation) and
the parameterization (see below) as before.
Otherwise, after booting Compact PLUS units go to status °005
drive setting, and Compact and chassis units go to status °000
power section definition.
The software version can be read in parameter r069.1, and the
extended software identifier in parameter r828.1.
The attached file Tech.pdf (German and English) contains further
information on enabling the technology functions F01 (synchronism
and positioning). This file can only be read with the Acrobat
Reader program.
Notes on Power Extension enable option F02 (operation of power
sections > 250 kW) can be found in Chapter 11.10 "Power
Extension PIN F02".
After removing the cable, you can make a start with parameterizing.
Compendium Motion Control
Functions
7-77