Status:questionable:integrity Condition Register Bits - Agilent Technologies ESA-E Series Programmer's Manual

Status Register s
Use Status Registers to Determine the State of Analyzer Events and Conditions
Bit
Decimal
Value
Description
8 256
Qpeak Align Failure A 1 in this bit position
indicates that a failure has occurred while trying t o
align the quasi-peak detector. (Agilent ESA- E700A
Series models only) .
9 512
unused This bit is always set to 0 .
10
1024
Tracking Peak Needed A 1 in this bit position
indicates that a tracking peak needs to be performe d
(the tracking generator is in operation) . (Agilent ESA
models E4402B, E4403B, E4405B, E4407B, an d
E4408B, Option 1DN, Tracking Generator, only) .
11 2048
Align RF Skipped A 1 in this bit position indicate s
that the alignment of the RF section was skipped ,
perhaps due to an external 50 MHz signal having
been detected.
12 4096
Align RF Needed A 1 in this bit position indicate s
that the RF section needs to be aligned .
13 8192
Reserved This bit is not used by the analyzer, but i s
for future use with other Agilent products .
14 16384
Align Needed A 1 in this bit position indicates that
a full alignment is needed, perhaps due to a large
temperature change having been detected with aut o
align off, or due to default data being used .
15 32768
Always zero (0) This bit is always set to O .
STATus:QUEStionable:INTegrity Condition Register
Bits
Bit
Decimal
Value
Descriptio n
0 0
Reserved This bit is not used by the analyzer, but is
for future use with other Agilent products .
1a 2
No Result Available A 1 in this bit position
indicates that a measurement terminated with n o
measurement results.
2a
4
measurement Timeout A 1 in this bit positio n
indicates that a measurement terminated due to a
timeout .
3
8
Data Uncalibrated Summary This is the summary
bit for the Questionable Status Integrity Uncalibrated
Register.
2-24 Chapter 2