Agilent Technologies ESA-E Series Programmer's Manual page 339

Error Messages
Informational Message s
Measurement halted . Press a measurement key to
continue .
This error occurs after you choose
Cancel
to refrain
from setting the attenuator to 0 dB during the Receiv e
Channel Power and Receive Spur measurements .
Not enough frequency range to measure
harmonics for channel .
Selected harmonics are above the frequency range o f
the instrument .
Option activate d
This message is displayed after entering the selecte d
option's License Key.
Please set RF input range (INPUT menu) t o
manual first .
In order to manually set the reference level and/or the
attenuation under the
Amplitude
front-panel key, th e
RF Input Range menu under the
Input
front-panel key
must be set to
Man
(manual).
Table loaded successfully .
When the
Load Table
key was pressed on the secon d
page of the edit table form while in the out-of-ban d
spurious measurement, the file was present . The
information has been loaded into the measuremen t
where it may be edited again by the user. This messag e
will also appear when the out-of-band spurious
measurement is opened if a spur table has been
previously saved .
Table saved successfully .
This message appears after the user presses the
Save Table
key on the second page of the edit table fo r
the out-of-band spurious measurement . It indicates
that the current spur table has been written
successfully to disk and is available to be loaded b y
means of the
Load Table
key.
Chapter 7 7-11