Agilent Technologies ESA-E Series Programmer's Manual page 366

Error Messages
Greater than 1000: Personality Specific Error Messages
10168 Cannot update the list of cable types on driv e
C :
The file update failed .
10179 Carrier Present . Test Stopped !
A carrier was found in the transmit band . Either
disable the carrier or insert a bandpass filter for th e
receive bandwidth.
10153 DSP algorithm timeout, aborting measuremen t
The Digital Signal Processor demodulation algorith m
timed-out for an unknown reason . This message
normally indicates a problem with the modulated
signal.
10230 DSP timed out, resetting DSP .
ingiLai oignai rrocessor was una p ie to nnisn me
selected measurement within the given period of time .
Restart the measurement.
10264 Emmision bandwidth not found . Conside r
increasing span .
This error is normally generated when attemptin g
occupied bandwidth measurements . The "X dB" value
you entered (Meas Setup, Emis BW X dB) to calculate the
emission bandwidth is the difference between th e
highest point on the trace and the point "X dB" down o n
either side of the maximum . If the actual difference is
less than the value entered, the emission bandwidt h
cannot be computed. Some responses to this situation
are as follows :
1. Connect a signal to the input . (If there is no signal
present, the difference between the trace minimum
and maximum will generally be less than "X dB".)
2. Increase the span . (If the signal is wide, the
shoulders of the signal might not be present on th e
screen, and again, the difference between the trac e
minimum and maximum will be less than "X dB" .)
7-38 Chapter 7