Agilent Technologies ESA-E Series Programmer's Manual page 168

Language Reference
IEEE Common Command s
If the state being loaded has an older firmware revisio n
than the revision of the instrument, the instrument wil l
only load the parts of the state that apply to the olde r
revision.
Front Panel
Access :
File, Recall State
Reset
*RST
This command presets the instrument to a factory defined conditio n
that is appropriate for remote programming operation . *RST i s
equivalent to performing the two commands : SYSTem: PRESet an d
*CLS . This command always performs a factory preset .
NOTE The preset performed by *RST is always a factory preset. That is, th e
same preset performed by : SYSTem : PRESet whe n
: SYSTem : PRESet :TYPE is set to FACTory.
Front Panel
Access :
Preset
Save
*SAV <register>
This command saves the instrument state to the specified instrumen t
memory register.
Range: Registers are an integer, 0 to 12 7
Remarks : See also commands :
MNDEMory : LOAD :
STATe an d
:MMEMory :STORe :STATe
Front Panel
Access :
File, Save State
Service Request Enable
*SRE <integer>
*SRE ?
This command sets the value of the service request enable register .
The query returns the value of the register .
Range : Integer, 0 to 255
5-8 Chapter 5