Agilent Technologies ESA-E Series Programmer's Manual page 319

Language Reference
TRIGger Subsystem
TRIGger Subsyste m
The TRIGger subsystem is used to set the controls and parameter s
associated with triggering the data acquisitions . Other trigger-related
commands are found in the INITiate and ABORt subsystems .
External Trigger, Line, and TV Trigger Delay Valu e
TRIGger[ :SEQuence] :DELay <delay>
TRIGger[ :SEQuence] :DELay ?
This command sets the amount of trigger delay when using the rea r
panel external trigger input, the front panel input with TV trigger, or
the line trigger.
Factory Prese t
and *RST: 1
µs
Range: 0.3
µs
to 429 second s
Default Unit: seconds
External Trigger, Line, and TV Trigger Delay Enabl e
:TRIGger[ :SEQuence] :DELay :STATe OFFIONIOI I
:TRIGger[ :SEQuence] :DELay :STATe?
This command allows you to turn on or off a delay, during which the
analyzer will wait to begin a sweep after receiving an external trigge r
signal, a front panel TV trigger, or a line trigger .
Factory Preset
and *RST :
Of f
Default Unit : seconds
Remarks : Free-run activates the trigger condition that allows th e
next sweep to start as soon as possible after the last
sweep. This function is not available when Gate is on .
Front Panel
Access : Trig, Trig Delay On Off
External Trigger Slop e
TRIGger[ :SEQuence] :EBTernal[1] :SLOPe POSitiveJNEGative
TRIGger[ :SEQuence] :EXTernal[1] :SLOPe ?
Chapter 5 5-159