Agilent Technologies ESA-E Series Programmer's Manual page 322

Language Reference
TRIGger Subsystem
Remarks: Free-run activates the trigger condition that allows th e
next sweep to start as soon as possible after the las t
sweep .
NOTE
Trigger Delay is not available in Free Run, so turning Free Run o n
turns off Trigger Delay, but preserves the value of Trigger Delay.
Set TV Field Mode
:TRIGger[ :SEQuence] :TV :FNODe ENTirelODDIEVEN
:TRIGger[ :SEQuence] :TV :FMODe ?
This command allows the user to determine how the fields of the T V
picture signal will be treated by the trigger system . This command is
available only on analyzers having Option B7B.
Factory Preset
and *RST: ENTire (entire frame)
Range : EN'I'ire (entire frame )
For formats NTSC-M, NTSC-Japan, and PAL-M, th e
minimum line is 1, and the maximum line is 525 .
For formats PAL-B, D, G, H, I, PAL-N, PAL-N Combin ,
and SECAM-L, the minimum line is 1, and the
maximum line is 625 .
ODD (Field 1 )
For formats NTSC-M, NTSC-Japan, and PAL-M, the
minimum line is 1, and the maximum line is 263 .
For formats PAL-B, D, G, H, I, PAL-N, PAL-N Combin ,
and SECAM-L, the minimum line is 1, and the
maximum line is 313 .
EVEN (Field 2)
For formats NTSC-M, NTSC-Japan, and PAL-M, th e
minimum line is 1, and the maximum line is 262 .
For formats PAL-B, D, G, H, I, PAL-N, PAL-N Combin ,
and SECAM-L, the minimum line is 1, and the
maximum line is 312 .
NOTE
Refer to chapter 6, Front-Panel Key Reference, in the Agilent ES A
Spectrum Analyzers User's Guide for a more detailed explanation of TV
fields and command dependencies .
Front Pane l
Access :
Trig, TV Trig Setup, Field, Entire Frame
Trig, TV Trig Setup, Field, Field On e
5-162 Chapters