Agilent Technologies ESA-E Series Programmer's Manual page 373

Error Messages
Greater than 1000: Personality Specific Error Messages
10170
The Cable Fault Measurement is active . Mode
Setup is disabled .
Mode setup is not available in the cable fault utility .
10177
There are no spurs to inspect .
The user has attempted to switch the Inspect Spu r
softkey to the
On
position after the measurement has
finished, but found no spurs .
10229 The regression portion failed .
This message occurs when (Option B7D) is not
functioning properly. Demodulation measurements
(modulation accuracy and code domain) might fail as a
result of this error.
10157
Tracking Generator hardware is not present .
Meas unavailable .
The measurement requires a built-in trackin g
generator.
Unable to uninstall personality, file not
deletable .
This message occurs when you try to delete a
personality which has been marked as non-deletable .
The personality is marked non-deletable at the factory .
Contact your nearest service center for furthe r
problems.
10144 Unknown demod status .
Demodulation is in an unknown state . Press
Preset .
If
the error persists, contact your service center.
10160 Upper Custom Mask is Invalid !
The user-specified upper custom mask cannot b e
resolved into a limit line. The format is incorrect.
Chapter 7 7-45