Agilent Technologies ESA-E Series Programmer's Manual page 312

Language Reference
TRACe Subsyste m
TRACe Subsystem
The TRACe subsystem controls access to the internal trace memory o f
the analyzer.
NOTE Refer also to : CALCulate and :1Mory subsystems for more trace an d
limit line commands .
Copy Trace
:TRACe :COPY <source trace>,<dest trace>
Transfers the source trace to the destination trace and leaves th e
destination trace in VIEW mode .
Source traces are : TRACE 11213, LLINE1, LLINE2, an d
RAWTRACE
Destination traces are : TRACE 112 ~ 3, LLINE1, LLINE2, and
RAWTRACE
Example :
:TRAC :COPY TRACE2,TRACE 1
Front Panel
Access: View/Trace, Operations, 1 -> 3
View/Trace, Operations, 2 -> 3
Transfer Trace Dat a
:TRACe[ :DATA] <trace_name> IRAWTRACE,<definite lengt h
block>I<ccama separated ASCII data>
:TRACe[ :DATA]? <trace_name> IRAWTRACEILLINE11LLINE 2
This command transfers trace data from the controller to the
instrument. The data format is set by the command :FORMat
[ :TRACe] [ :DATA] . The data is comma-separated ASCII values in
ASCII formatting, and a definite length block in REAL, INTeger, an d
UINTeger formatting .
The query returns the current values of the designated trace. The data
is terminated with <NL><END> (for GPIB that is newline, or linefeed ,
followed by EOI set true ; for RS-232 this is newline only.)
LLINE1 and LLINE2 can only be queried ; they cannot be set .
<trace_name> is TRACE11 2 ~ 3
5-152 Chapter 5