Agilent Technologies ESA-E Series Programmer's Manual page 193

Language Reference
CALCulate:MARKer Subsectio n
Factory Preset
and *RST: Off
Remarks: When a measurement under the front panel MEASURE
key is started, this command is turned off . If this
command is turned on when any of the MEASURE ke y
measurements are in progress, that measurement wil l
be stopped .
Front Panel
Access : FREQUENCY/Channel, Signal Track On Of f
Marker X Valu e
:CALCulate :MARKer[1]121314 :X <param>
:CALCulate :MARKer[1]121314 :X ?
Position the designated marker on its assigned trace at the specified
trace X value . The value is in the X-axis units (which is often frequency
or time).
The query returns the current X value of the designated marker .
Default Unit : Matches the units of the trace on which the marker i s
positioned
Front Panel
Access:
Marke r
Span Markers Center Frequency X Value
:CALCulate :MARKer[1]121314 :X:CENTer <param>
:CALCulate :MARKer[l)I21314 :X:CENTer ?
Position the center frequency, of the designated span-type marker pair,
at the specified trace X value. The value is in the X-axis units (which i s
often frequency or time) Use :CALCulate :MARKer :MODE SPAN to
select span markers .
The query returns the current X-value center frequency of the
designated markers .
Range : Matches the units of the trace on which the markers
are positioned
Front Panel
Access:
Marker, <active marker>, Cente r
Marker X Position
:CALCulate :MARKer[1]121314 :X :POSition <integer>
:CALCulate :MARKer[1]121314 :X :POSition ?
Chapter 5 5-33