Agilent Technologies ESA-E Series Programmer's Manual page 359

Error Message s
201 to 799 : Device-Specific Error s
763 Incorrect filename, allowable extensions ar e
.gif or .wmf
Attempt to save a screen image to a file with an
incorrect extension .
762 Incorrect filename, allowable extensions ar e
.trc or .csv
Attempt to save a trace to a file with an incorrect
extension .
770 Instrument mode requested is not supporte d
Instrument mode specified with :INST command is not
valid . Refer to "INSTrument Subsystem" in Chapter 5
for more information.
751 Instrument state may be corrupt, state ha s
been reset to initial value s
An error in the internal instrument state has bee n
detected. The state has been reset to a default value .
734 Interpolation error : cannot compute log o f
<negative_frequency_value>
Occurs when the frequency interpolation of a limit line
is set to log and the start frequency of the instrument is
negative. The <negative_frequency_value> is limited t o
- 80 MHz, so it may not match the frequency that
caused the error.
216 Invalid Baud Rat e
Attempt to use invalid baud rate . Refer to
"INSTrument Subsystem" in Chapter 5 for mor e
information.
Chapter 7 7-31