Agilent Technologies ESA-E Series Programmer's Manual page 221

Language Referenc e
INITiate Subsystem
Restart the Measurement
:INITiate :RESTart
This command applies to measurements found in the
MEASURE
menu.
Use this command to restart the present measurement from the "idle"
state, regardless of its operating state . It is equivalent to
INITiate [ : 'Mediate] for single measurement mode, or :ABOR t
for continuous measurement mode.
Front Pane l
Access:
Restart
Meas Control, Restart
Resume the Measurement
: INITiate : REStm:e
This command applies to measurements found in the MEASURE menu.
Use this command to resume the current measurement by changing th e
current measurement state from the "paused" state back to the "wai t
for trigger" state.
Front Panel
Access:
Meas Control, Resume
Chapter 5
5-61