Language Reference
SENSe Subsyste m
SENSe Subsystem
Sets the instrument state parameters so that you can measure the
input signal .
SENSe subsystem commands used for measurements in the
MEASUR E
and Maas
Setup
menus may only be used to set parameters of a specifi c
measurement when the measurement is active . Otherwise, an error wil l
occur. You must first select the appropriate measurement using th e
: CONFigure : <measurement> command. If a : SENSe command i s
used to change a parameter during a measurement (while not in its idl e
state), the measurement will be restarted .
5-82
Chapter 5