Agilent Technologies ESA-E Series Programmer's Manual page 199

Language Reference
CONFigure Subsystem
CONFigure Subsyste m
CONFigure subsystem commands apply only to measurements found in
the
MEASURE
menu. These commands stop the current measurement
and set up the instrument for the specified measurement using th e
factory default instrument settings .
: CONFigure : <measurement> will always set : INITiate :
CONTinuous OFF (single mode), and also places the measurement i n
the idle state .
: CONFigure : SANalyzer causes the present measurement to exit
(functionally the same as pressing MEASURE, Mess Off), and places the
analyzer in base instrument spectrum analyzer state .
The query : CONFigure? returns the current measurement name in
quotes .
Configure the Adjacent Channel Powe r
Measurements
CONFigure :ACPower
Configure the Channel Power and Density
Measurements
CONFigure :CHPowe r
Configure the Emission Bandwidth Measurement s
CONFigure :ESWidth
Configure the Harmonic Distortion Measurement s
CONFigure :HARMonic s
Configure the OBW and Transmit Frequency Erro r
Measurements
CONFigure :OBWidt h
Chapter 5
5-39