Agilent Technologies ESA-E Series Programmer's Manual page 264

Language Reference
[ :SENSe] :HARMonics Subsectio n
[:SENSe]:HARMonics Subsection
Harmonic Measurement Averages
[ :SENSe] :HARMonics :AVERage :COUNt <integer>
[ :SENSe] :HARMonics :AVERage :COUNt ?
Set the number of averages for the harmonic measurement.
Factory Prese t
and *RST: 10
Range : 1 to 1,000
Remarks : This command specifies the number of sweep average s
over which the amplitude of each harmonic and th e
total harmonic distortion will be calculated .
Intermediate averaged results will be displayed .
Front Pane l
Access :
Meas Setup, Avg Number O n
Turn On or Off Harmonic Measurement Averagin g
[ :SENSe] :HARMonics :AVERage[ :STATe] OFFIONIO1 l
[ :SENSe] :HARMonics :AVERage[ :STATe] ?
Turn on or off harmonic measurement averaging.
Factory Preset
and *RST : Of f
Front Pane l
Access :
Meas Setup, Avg Numbe r
Set Number of Measured Harmonics
[ :SENSe] : HARMonics :NUMBer <integer >
[ :SENSe] :HARMonics :NUMBer ?
Set the number of harmonics to be measured .
Factory Preset
and *RST : 10
Range : 2 to 10, limited by the maximum frequency range of the
analyzer
5-104
Chapter 5