Agilent Technologies ESA-E Series Programmer's Manual page 323

Language Referenc e
TRIGger Subsyste m
Trig, TV Trig Setup, Field, Field Tw o
Set TV Line Number for Synchronizatio n
:TRIGger[ :SEQuence] :TV :LINE <line >
:TRIGger[ :SEQuence] :TV :LINE ?
This command allows you to set the TV line number to which the
analyzer will synchronize its sweep . This command is available only on
analyzers having Option B7B.
Factory Preset
and *RST: 17
Range : The range is dependent upon the Field Mode, a s
described in the command
:TRIGger[ :SEQuence] :TV :FMODe ENTirelODDIEVEN .
The minimum value is the minimum line, and rolls ove r
to the maximum value . The maximum value is the
maximum line, and rolls over to the minimum value .
Remarks : Refer to the command
: TRIGger [ : SEQuence] : SOURce : TV which is used to
activate TV triggering.
Set Analyzer for TV Picture Monitorin g
:TRIGger[ :SEQuence] :TV :MONitor OFFIONIO1 1
:TRIGger[ :SEQuence] :TV :MONitor?
The currently-selected standard is used to determine the proper setu p
of the hardware state of the video digitization circuitry for presentatio n
of the TV picture . This command is available only on analyzers havin g
Option B7B.
Factory Prese t
and *RST: Of f
Front Panel
Access :
Trig, TV Trig Setup,TV Monitor
Set the Video Waveform Sync . Pulse Directio n
:TRIGger[ :SEQuence] :TV :SLOPe POSitivelNEGative
:TRIGger[ :SEQuence] :TV :SLOPe ?
This command defines the direction of the sync pulse on the TV vide o
waveform. This command is available only on analyzers having Option
B7B .
Chapter 5
5-163