Agilent Technologies ESA-E Series Programmer's Manual page 369

Error Messages
Greater than 1000 : Personality Specific Error Messages
10161 Lower Custom Mask is Invalid !
The user-specified lower custom mask cannot b e
resolved into a limit line.
10231 Measurement failed for unknown reasons .
Check instrument settings and restart measurement .
10154 Measurement not defined for Out of Band .
User has changed to an out-of-band frequency range .
The band measurement only operates in the selecte d
band .
10227 Measurement suspended until carrier is turne d
off .
The receive channel power and the receive spur
measurements are specified with the attenuation set t o
0 dB. To prevent overload, the frequency spectrum of
interest is monitored for signal levels which exceed a
specified threshold before setting the attenuator to
0 dB. If a carrier is found, this message is displayed and
the completion of the measurement will not occur until
the carrier is removed. The carrier check may be turne d
off using the properties form under the front-panel
Mode Setup key . You may also change the signal
threshold which determines a carrier on the properties
form .
10155 No Fast ADC hardware installed . Meas
unavailable .
The analyzer cannot use sweeptimes less than 5 mse c
when (Option B7D or Option AYX) is not installed .
Therefore the measurement will not be executed .
10147 Opt B7D bootrom requires upgrade .
The (Option B7D) bootrom revision is not supported by
the curently loaded personality version. Refer to the
user's guide for the personality in use .
Chapter 7
7-41