Agilent Technologies ESA-E Series Programmer's Manual page 364

Error Messages
201 to 799: Device-Specific Error s
207 Unable to store flatness data
A failure occurred in setting the flatness data in th e
internal EEROM . Contact your local Agilen t
Technologies sales and service office .
703 Unknown printer
In attempting to identify the printer, a valid response
was received but the printer is not known to th e
analyzer. Use the
Custom
printer menu under Print
Setup to configure the printer.
702 Unsupported printer
A printer which is recognized, but known to be
unsupported was identified . This printer cannot b e
used with the analyzer. For example, a printer onl y
supported by Microsoft Windows will generate thi s
error.
The floppy disk has the wrong density. It should be
1.44 MB .
7-36 Chapter 7