Agilent Technologies ESA-E Series Programmer's Manual page 278

Language Reference
[:SENSe] :SWEep Subsection
NOTE
This command applies to the following models having firmware revisio n
A.05 .00 or later:
E4401B
E4402B
E4404B
E4405B
E4407B
Factory Preset
and *RST : 0
Range: 0 to 32
Set All Segment Data
[ :SENSe] :SWEep :SECent :DATA[ :ALL] <SSTopICSPan>,<coam a
separated data in ASCII>
[ :SENSe] :SWEep :SEGNent :DATA[ :ALL]? <SSTopICSPan>
Specify parameters for all segments of a segmented sweep. The data is
entered as comma-separated ASCII values in sequential order o f
segments desired . Segments will be sorted in order of increasing star t
frequency. If multiple segments have the same start frequency, they wil l
appear in order of increasing stop frequency. It is possible to define
segments that overlap .
For SSTop, the data order used for each segment is : start frequency,
stop frequency, resolution bandwidth, video bandwidth, number of
points, and sweep time.
For CSPan, the data order used for each segment is : center frequency,
span, resolution bandwidth, video bandwidth, number of points, an d
sweep time.
NOTE
This command applies to the following models having firmware revisio n
A.05 .00 or later:
E4401B
E4402B
E4404B
E4405B
E4407B
NOTE
Command [ : SENSe ] : SWEep : SEGMent :DATA [ :ALL] will delete any
previous segment data .
Example: : SENSe : SWEep : SEGMent : DATA : ALL
CSPan,50e06,5e6,1e5,1e5,101, .0050,1e09,5e6
,le5,1e5,101, .05
5-118 Chapter 5